| Last additions - (3) CUSTOMER PHOTOS |
Folks, this is what I call a KILLER MOBILE!858 viewsNo, that's not a toy truck in the photo, you're looking at Philip's 32 ft. whip, on the BKT-Sksp-1 and Shakespeare spring base. Maybe too long for the highway but what a stationary mobile setup, especially with his long counterpoise wires.May 03, 2010
|
|
Closeup shows base of Tarheel antenna and AMB-Gnd-1.434 viewsNo counterpoise is attached in this view.May 01, 2010
|
|
CLAMP150 vertically mounted to deck post, with Tarheel antenna.368 viewsMay 01, 2010
|
|
571 viewsMay 01, 2010
|
|
Note how antenna fits in his garage - whip is unscrewed!526 viewsMay 01, 2010
|
|
647 viewsMay 01, 2010
|
|
BKT-NissanTrac-4 (black PC) slide-in mount with Scorpion antenna.447 viewsThis is a shorter version of their great antennas. May 01, 2010
|
|
Closeup of Scoprion antenna features.220 viewsNote these unique features of Scorpion antennas: the bottom bolt is a hefty 3/4" and it's at ground potential, come with SO239 connector and shunt coil.May 01, 2010
|
|
164 viewsMay 01, 2010
|
|
147 viewsMay 01, 2010
|
|
Closeup of BKT-NissanTrac-4 and base of Scorpion antenna.122 viewsMay 01, 2010
|
|
116 viewsMay 01, 2010
|
|
BKT-HondaRL-1: With Honda cover partially opened.142 viewsThe HondaRL bolts (no drilling) to the upper Honda tie down brackets, above the Honda bed cover. May 01, 2010
|
|
View from the rear - HondaRL mount looks factory installed!133 viewsMay 01, 2010
|
|
Another rear view.114 viewsHonda cover is completely closed.May 01, 2010
|
|
Angle view of BKT-HondaRL-1 with Larry's three antennas.121 viewsThe left antenna is an ATAS HF antenna, the others are V/UHF. May 01, 2010
|
|
118 viewsMay 01, 2010
|
|
BKT-NissanTrac-1 + UHAM200 mount, for Hi Q antenna on Nissan Titan.154 viewsUHAM200 bolts to the NissanTrac bracket, which slides into Nissan's handy "utility track" on the left or right sides.May 01, 2010
|
|
144 viewsMay 01, 2010
|
|
UHAM150 (buffed Al), closeup view.111 viewsMay 01, 2010
|
|
His antenna is used on back roads in Idaho.142 viewsMay 01, 2010
|
|
SHUNT100 on front bumper, for Hi Q antenna.134 viewsMay 01, 2010
|
|
Gerard's email to me from "down under" about the SHUNT100.92 viewsMay 01, 2010
|
|
UHAM150 mounted to edge of roof, with Hi Q antenna.179 viewsNotice the newer "egg beater" type capacity hat!May 01, 2010
|
|
SHUNT100 with modified mounting plate, with mount off vehicle.95 viewsMay 01, 2010
|
|
Same, showing Hi Q antenna on vehicle.119 viewsMay 01, 2010
|
|
SHUNT100122 viewsMay 01, 2010
|
|
SHUNT100133 viewsMay 01, 2010
|
|
Email to me describing his experience installing the SHUNT100.88 viewsMay 01, 2010
|
|
AMB-AntExtend-2.5 on mount with Hi Q antenna stud (no antenna).134 viewsMay 01, 2010
|
|
Closeup to see how the AMB-AntExtend looks with the Hi Q antenna.99 viewsThe antenna is above the silver colored ring (the Hi Q stud the antenna screws into; the bottom of this stud screws into the extension with provided hardware).May 01, 2010
|
|
78 viewsMay 01, 2010
|
|
CLoseup showing the extension and the Hi Q antenna - look great together!75 viewsThe extension is between the antenna and the mount.May 01, 2010
|
|
View of extension on mount.122 viewsMay 01, 2010
|
|
72 viewsMay 01, 2010
|
|
AMB-AntExtend-2.5: one foot extension for Hi Q "ruggedized" HF motorized antenna.156 viewsNote how the extension places the antenna coil above the roof line - without extension coil was too low. Made from solid aluminum with both ends tapped 1/2x20 to fit the Hi Q mounting hardware.May 01, 2010
|
|
UHAM mount + SARM100 horizontal extension.85 viewsThis places the antenna to the side of the license plate and can pull a trailer at the same time.May 01, 2010
|
|
Closeup of AMB-Arm2 mounted to CLAMP150 on home balcony.122 viewsThis is the PRODUCTION version of the Arm2.May 01, 2010
|
|
UHAM mount + SARM100 to use bike rack with antenna.73 viewsMay 01, 2010
|
|
N7EMW's mobile - IC700, power panel and DC-DC converter.91 viewsThe DC-DC converter makes up for voltage loss - do not have the space to run heavier cable.May 01, 2010
|
|
N7EMW's mobile - fuse panels and power control boxes.79 viewsMay 01, 2010
|
|
N7EMW's mobile.92 viewsMay 01, 2010
|
|
N7EMW's mobile.79 viewsMay 01, 2010
|
|
N7EMW's mobile.248 viewsMay 01, 2010
|
|
CLAMP150 with 12ft. whip tuned by Elecraft T-1 QRP autotuner.72 viewsAlso visible is a AMB-Gnd-8 "counterpoise ring" with four radials. First test using auto tuner. Saves weight over using screwdriver antenna.May 01, 2010
|
|
(closeup of previous view)87 viewsCLAMP150 is mounted horizontally to CURVED wood railing. No other clamp mount can do this.May 01, 2010
|
|
CLAMP150-W - final production version of WiFi panel antenna "clamp to anything" mount.74 viewsMay 01, 2010
|
|
CLAMP150-W, prototype version for WiFi panel antenna.80 viewsThis enabled me to pick up our hotel's public WiFi hundreds of feet away. Without the antenna I could not connect to WiFi reliably with my laptop's internal WiFi antenna.May 01, 2010
|
|
CLAMP150 mounted to a 1/2" thick plywood wind break for grill.68 viewsLocated on Cape Cod, looking across the bay towards Boston.May 01, 2010
|
|
N7EMW's modifed FT-817.188 viewsMay 01, 2010
|
|
| 94 files on 2 page(s) |
 |
1 | |
|
